![]() Hi Matty, I'd like to briefly reply to this previous message you sent me:ġ) why should I remove R51 resistence (also if the cable is working fine?)?Ģ) I updated suggested ept file on ftdi by Mprog īy PonyProg2000 I updated firmware (1.92) + eeprom (vers. RE: Help: how to repair vcds china cable 12.10.3 - sgtpepper67 - 09-10-2015 Maybe should I connect the interface to the car now to change it from NOT READY to OK? Tried with both 11.11.5 and 12.12.0 and now license is fully (green color) and test is ok with K1,K2 except CAN:NOT READY, still not ready. I have flashed again the atmega162 with firmware v.1.92 + eeprom vers 6 11.11.5-12.12.0_eeprom 512 rl.hex and used fuse/bits as 320 (not 512). ![]() Then go to About and see if its ActivatedĪntivirus to check if you have a virus there. Install the vcds software 11.11.5 and/or 12.12.0 I will also reply asap with all the needed info. Now I have re-flashed all again and I have again CAN:NOT READY but immediately after the test I got another message with "license not found". RE: Help: how to repair vcds china cable 12.10.3 - sgtpepper67 - 08-10-2015
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |